make sure the application surface is
absolutely clean.
Measure and trim the film to the size
required.
Leave the adhesive backing on and
roll the sheet over the hood.
Normally, two people are
recommended for large application
like a hood.
Peel off part of the paperback and
pull each corner tight to leave as
little creases and bubbles as
possible.
It is best to have someone
else hold and stretch the film, while
you apply it.
Use the heat to stretch the film and
work the film to the desired position.
You can have one person stretching
the vinyl and the other heating and
smoothing.
Use a squeegee to work the film into
the place and push out remaining
creases or trapped air bubbles.
Peel off the remaining paperback and
repeat the previous step.
Use your blade to cut around the
edges and trim the excess film and
then fold it under the edge.
Hi,
ReplyDeleteCould you please assist me to trace a person who could effectively wrap carbon fibre on a few parts of my car? & Yes Please assist in getting hold of someone who can paint carbon fibre too
I would be on my following Watsaap number: 9620152780